*: Use the intelligent tester
Use the following procedure to troubleshoot the hybrid control system.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
If the display on the tester indicates a communication fault, inspect the DLC3.
| Proceed to |
|---|
| NEXT |
NEXT
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DTC CHECK / CLEAR
Make sure to save freeze frame data because the data is necessary for a simulation test.
For the hybrid control system, there are many DTCs, many of which can be stored due to a single malfunction. As a result, in some of the diagnosis procedures an instruction is provided to check for other DTCs and their corresponding INF codes. By following the diagnosis path based on the combination of output DTCs and INF codes, it is possible to narrow down the problem early and avoid unnecessary diagnosis.
| Proceed to |
|---|
| NEXT |
NEXT
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
If the engine does not start, perform steps 9 and 17 first.
| Result | Proceed to |
|---|---|
| Malfunction does not occur. | A |
| Malfunction occurs. | B |
A
B
| Proceed to |
|---|
| NEXT |
NEXT
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC is output. | A |
| DTC is not output. | B |
A
B
DTCs for the hybrid control system and hybrid battery system are displayed using the same menus on the intelligent tester. It is necessary to check the DTC charts for hybrid control system and hybrid battery system.
Hybrid Control System - DTC chart
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
Hybrid Battery System - DTC chart
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
| Proceed to |
|---|
| NEXT |
NEXT
| Result | Proceed to |
|---|---|
| Malfunction not confirmed. | A |
| Malfunction confirmed. | B |
A
B
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Result | Proceed to |
|---|---|
| Malfunctioning parts not confirmed. | A |
| Malfunctioning parts confirmed. | B |
A
B
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT