The skid control ECU receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system.
The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.
| DTC No. | Detection Item | INF Code | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|---|
| C1442/44 | Invalid Data Received from Acceleration Sensor | 572 | With terminal IG1 voltage between 9.5 and 17.4 V, an invalid data signal is received from the acceleration sensor for 10 seconds or more. | Acceleration sensor (Airbag sensor assembly) | ABS DTC |
| C1443/34 | Invalid Data Received from Yaw Rate Sensor | 715 | With terminal IG1 voltage between 9.5 and 17.4 V, an invalid data signal is received from the yaw rate sensor for 10 seconds or more. | Yaw rate sensor (Airbag sensor assembly) | VSC DTC |
When replacing the yaw rate and acceleration sensor (airbag sensor assembly), perform zero point calibration.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>CALIBRATION
Clear the DTCs.
Check if the same DTC is output.
| Result | Proceed to |
|---|---|
| DTCs C1442/44 and C1443/34 are not output. | A |
| DTCs C1442/44 and/or C1443/34 are output. | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B