CHECK FOR INTERMITTENT PROBLEMS
A momentary interruption (open circuit) in the connectors and/or wire harnesses between the sensors and ECUs can be detected using the Data List function of the intelligent tester.
Turn the power switch off.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Follow the directions on the intelligent tester to display the Data List and select areas where momentary interruptions should be monitored.
A momentary interruption (open circuit) cannot be detected for 3 seconds after the power switch is turned on (IG) (initial check).
If Error remains displayed for one of the items on the intelligent tester, check for continuity between the ECU and the item for which Error is displayed.
If a momentary interruption occurs and Error is displayed on the intelligent tester, Error will remain displayed on the intelligent tester for 1 second after the circuit returns to normal.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| FR Speed Open | Front speed sensor RH open detection | Error or Normal | Error: Momentary interruption
Normal: Normal |
- |
| FL Speed Open | Front speed sensor LH open detection | Error or Normal | Error: Momentary interruption
Normal: Normal |
- |
| RR Speed Open | Rear speed sensor RH open detection | Error or Normal | Error: Momentary interruption
Normal: Normal |
- |
| RL Speed Open | Rear speed sensor LH open detection | Error or Normal | Error: Momentary interruption
Normal: Normal |
- |
| Yaw Rate Open | Yaw rate sensor open detection | Error or Normal | Error: Momentary interruption
Normal: Normal |
- |
| Deceleration Open | Acceleration sensor open detection | Error or Normal | Error: Momentary interruption
Normal: Normal |
- |
| Steering Open | Steering angle sensor open detection | Error or Normal | Error: Momentary interruption
Normal: Normal |
- |
| Master Cylinder Open | Regulator pressure sensor open detection | Error or Normal | Error: Momentary interruption
Normal: Normal |
- |
| Stroke Open | Brake pedal stroke sensor assembly open detection | Error or Normal | Error: Momentary interruption
Normal: Normal |
- |
| FR Wheel Cylinder Open | Wheel cylinder pressure sensor open detection | Error or Normal | Error: Momentary interruption
Normal: Normal |
- |
| Accumulator Open | Accumulator pressure sensor open detection | Error or Normal | Error: Momentary interruption
Normal: Normal |
- |
| HV Communication Open | Hybrid vehicle communication open detection | Error or Normal | Error: Momentary interruption
Normal: Normal |
- |
While observing the screen, gently jiggle the connectors or wire harnesses between the ECUs and sensors, or between ECUs.
Normal is displayed.
If the display changes, this indicates that there has been a momentary interruption (open circuit) in the connector and/or wire harness. In this case, repair or replace the connectors and/or wire harnesses as one of them is faulty.