| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2789 | No Response from ID BOX | An internal malfunction occurs in the certification ECU (smart key ECU assembly) | Certification ECU (smart key ECU assembly) |
When using the intelligent tester to troubleshoot with the power switch off:
Connect the intelligent tester to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the intelligent tester and vehicle begins.
If the certification ECU (smart key ECU assembly) is replaced, register the keys (refer to the Service Bulletin).
Clear the DTCs.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
DTC B2789 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG