Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function) › 2012.02–2015.04
RM2040EQ _56 Audio / Visual / Telematics _014718 PARK ASSIST / MONITORING _0075024 PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function) D

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function)  DTC CHECK / CLEAR  


CHECK DTC


a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Navigation System / DTC.

Body Electrical > Navigation System > Trouble Codes
50001 212

e.

Check for DTCs and then write them down.


f.

Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function)>DIAGNOSTIC TROUBLE CODE CHART).

NOTICE:

The navigation system outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the navigation system are output, refer to Diagnostic Trouble Code Chart for the relevant system.

System Proceed to
Navigation system (Click here)




CLEAR DTC


a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Navigation System / DTC.

Body Electrical > Navigation System > Clear DTCs
50002 212

e.

Clear the DTCs.