Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function) › 2012.02–2015.04
RM2040EQ _56 Audio / Visual / Telematics _014718 PARK ASSIST / MONITORING _0075024 PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function) J

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function)  Guide Lines are Displayed with Vehicle Center Line  


DESCRIPTION

The rear television camera assembly can create parking guide lines. Because this function is not necessary on vehicles with the parking assist monitor system, the guide line creation function of the rear television camera assembly is disabled.

WIRING DIAGRAM

E224386E02
3.323,1.104 5.74,1.458 2.417,0.354 10 Rear Television Camera Assembly 2.625,0.292 2.802,0.479 0.177,0.188 10 1 2.813,0.406 3.313,0.594 0.5,0.188 10 CURT 3.313,0.927 3.813,1.115 0.5,0.188 10 T6

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function)>CALIBRATION


PROCEDURE

1.CHECK SCREEN MODE
a.
E226200C01
2.499,0.326 2.825,0.532 0.326,0.206 10 *a 1.782,1.267 2.467,0.432 2.467,0.432 1.832,1.492 false 2.467,0.432 1.89,1.643 false
*a Vehicle Center Line


Check the back guide monitor screen.


Result:
Result Proceed to
Guide lines are displayed with vehicle center line. A
Guide lines are displayed without vehicle center line. B



A

2.CHECK HARNESS AND CONNECTOR (REAR TELEVISION CAMERA ASSEMBLY - BODY GROUND)

B

2.CHECK HARNESS AND CONNECTOR (REAR TELEVISION CAMERA ASSEMBLY - BODY GROUND)
a.
E226197C03
1.504,1.269 0.876,1.269 false 0.369,1.188 0.89,1.351 0.521,0.163 10 CURT 1.506,0.171 1.993,0.463 0.487,0.292 1.631,0.228 1.818,0.409 0.187,0.182 10 T6 0.16,0.099 0.68,0.263 0.521,0.163 10 *a
*a Front view of wire harness connector
(to Rear Television Camera Assembly)


Disconnect the T6 connector from the rear television camera assembly.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
T6-1 (CURT) - Body ground Always Below 1 Ω




Result:
Proceed to
OK
NG



OK

REPLACE REAR TELEVISION CAMERA ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR