CUSTOMIZE LIGHTING SYSTEM (INT)
The following items can be customized.
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
Customizing using the intelligent tester
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Utility / Customize / Illuminated Entry.
Select the setting by referring to the table below.
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Lighting Time | Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the power switch from off on (IG) or on (ACC).) | 15 s | 10:30 s,00:15 s,01:7.5 s | Main body ECU (Multiplex network body ECU) |
| I/L when ACC OFF | Lights up the power switch illumination, personal light*1 and rear interior light when the power switch is turned from on (IG) or on (ACC) to off. | ON | 0:OFF,1:ON | Main body ECU (Multiplex network body ECU) |
| I/L ON W/Door Key Unlock | Lights up the power switch illumination, personal light*1 and rear interior light when doors are unlocked using a mechanical key or door control transmitter. | ON | 0:OFF,1:ON | Main body ECU (Multiplex network body ECU) |
| Room Light when Aprchd | Lights up the power switch illumination, personal light*1 and rear interior light when a key enters any actuation area around the doors. | ON | 0:OFF,1:ON | Main body ECU (Multiplex network body ECU) |
| Interior Light Control | Lights up the power switch illumination, personal light*1 and rear interior light when the illuminated entry function is operating. | ON | 0:OFF,1:ON | Main body ECU (Multiplex network body ECU) |
*1: w/ Sliding Roof
Customizing using the Multi-display (for Navigation Receiver Type)
Turn the power switch on (IG).
Enter the following menus: SETUP / Vehicle / Vehicle customization / Light Settings
Select the setting by referring to the table below:
| Display | Default | Content | Setting | Relevant ECU |
|---|---|---|---|---|
| Interior Lights Off Timer | 15 sec. | Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the power switch from off to on (ACC) or on (IG).) | Off, 7.5 sec., 15 sec., or 30 sec. | Main body ECU (Multiplex network body ECU) |