Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM2040EQ _58 Vehicle Interior _014730 HEATING / AIR CONDITIONING _0075108 AIR CONDITIONING SYSTEM J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  IG Power Source Circuit  


DESCRIPTION

Power is supplied to the air conditioning amplifier assembly when the power switch is turned on (IG).

The power is used for operating the air conditioning amplifier assembly, servo motors, etc.

WIRING DIAGRAM

E229257
5.938,2.125 6.396,2.302 0.458,0.177 10 false GND 5.729,0.76 5.833,0.938 0.104,0.177 10 false 1 5.656,2.042 5.833,2.219 0.177,0.177 10 false 14 5.469,3.469 5.792,3.646 0.323,0.177 10 false I77 5.469,3.646 7.063,3.979 1.594,0.333 10 false Air Conditioning Amplifier Assembly 0.052,1.573 1.615,2.135 1.563,0.563 10 false from Power Management Control ECU 5.938,0.854 6.385,1.031 0.448,0.177 10 false IG+ 4.521,1.188 5.208,1.365 0.688,0.177 10 false A/C-IG1 3.042,1.906 3.802,2.083 0.76,0.177 10 false IG1 NO. 1 0.24,0.938 1.792,1.313 1.552,0.375 10 false from Auxiliary Battery

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - AUXILIARY BATTERY)
a.

Disconnect the I77 air conditioning amplifier assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
I77-1 (IG+) - Body ground Power switch off Below 1 V
I77-1 (IG+) - Body ground Power switch on (IG) 11 to 14 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I77-14 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR