DTC B124D is stored when the main body ECU (multiplex network body ECU) detects malfunctions in the LIN communication system.
DTC B2432 is stored when the AFS ECU (headlight swivel ECU assembly) detects malfunctions in the LIN communication system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B124D | Lost Communication with AFS LIN | Malfunction in LIN communication system | ·
Inner rear view mirror assembly ·
Harness or connector ·
AFS ECU (headlight swivel ECU assembly) |
| B2432 | Lost Communication with Automatic High Beam Sensor | Malfunction in LIN communication system | ·
Inner rear view mirror assembly ·
Harness or connector ·
AFS ECU (headlight swivel ECU assembly) |
First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before performing the following inspection.
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>DTC CHECK / CLEAR
DTC B124D or B2432 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Disconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.
Disconnect the S2 inner rear view mirror assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-11 (RHT) - S2-5 (LIN) | Always | Below 1 Ω |
| S2-5 (LIN) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Reconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.
| *a | Front view of wire harness connector
(to Inner Rear View Mirror Assembly) |
Connect an oscilloscope to the S2 inner rear view mirror assembly connector.
Check the waveform.
| Tester Connection | Tool Setting | Condition | Specified Condition |
|---|---|---|---|
| S2-5 (LIN) - S2-1 (E) | 2 V/DIV., 20 ms./DIV. | Power switch on (IG) | Correct waveform is as shown |
| Proceed to |
|---|
| OK |
| NG |
OK
NG