FREEZE FRAME DATA
Whenever a DTC is detected, the AFS ECU (headlight swivel ECU assembly) stores the current vehicle (sensor) state as Freeze Frame Data.
CHECK FREEZE FRAME DATA
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / AFS / DTC.
According to the display on the intelligent tester, select the trouble code data display with Freeze Frame Data.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Traveling Direction | Traveling Direction | Not Fwd or Fwd | Not Fwd: Shift lever in R or N
Fwd: Shift lever in any position other than R or N |
- |
| Headlight Low Beam State | Low beam headlight state | ON or OFF | ON: Low beam headlights on
OFF: Low beam headlights off |
- |
| Headlight High Beam State | High beam headlight state | ON or OFF | ON: High beam headlights on
OFF: High beam headlights off |
- |
| Engine | Engine condition | Run or Stop | Run: Engine running
Stop: Engine stopped |
- |
| Steering Sens Signal | Steering angle sensor signal value | -384.0 deg to 382.5 deg | Condition can be displayed | - |
| FR Wheel Speed | Front right wheel speed | 0.00 to 327.67 km/h (203.61 mph) | Condition can be displayed | - |
| FL Wheel Speed | Front left wheel speed | 0.00 to 327.67 km/h (203.61 mph) | Condition can be displayed | - |
| Vehicle Acceleration | Vehicle acceleration | -455.65 to 445.60 m/s2 | Condition can be displayed | - |
| +B | IG power supply voltage value | 0.00 to 19.75 V | 11 to 14 V | - |
CLEAR FREEZE FRAME DATA
Clearing the DTCs will also clear the Freeze Frame Data.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Clear the DTC and Freeze Frame Data (See page Vehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>DTC CHECK / CLEAR).