Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY COOLING DUCT(w/ Filter)
RM2040EQ _51 Engine / Hybrid System _014692 HYBRID / BATTERY CONTROL _0109199 BATTERY COOLING DUCT(w/ Filter) G

HYBRID / BATTERY CONTROL  BATTERY COOLING DUCT(w/ Filter)  INSPECTION  


PROCEDURE

Hide 1.INSPECT NO. 1 HYBRID BATTERY INTAKE FILTER

a.

Inspect No. 1 hybrid battery intake filter.

Standard:

No clogs or damage.


NOTICE:
·

If the No. 1 hybrid battery intake filter is damaged, replace it with a new one.

·

If the No. 1 hybrid battery intake filter is damaged, check for foreign matter in the battery cooling blower assembly. Clean or replace the battery cooling blower assembly if necessary.




b.

Clean the No. 1 hybrid battery intake filter.

NOTICE:
·

Clean the No. 1 hybrid battery intake filter with an air blow gun. Do not use water or any other liquid.

·

Do not use a wire brush or any other type of brush as it may damage the No. 1 hybrid battery intake filter.

·

To prevent removed foreign matter from entering the HV battery, make sure to remove the No. 1 hybrid battery intake filter when cleaning it.



i.

Using an air blow gun, clean the No. 1 hybrid battery intake filter.