Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR(for Front Side) › from 2015.04
RM2040EQ _56 Audio / Visual / Telematics _014718 PARK ASSIST / MONITORING _0164630 ULTRASONIC SENSOR(for Front Side) A

PARK ASSIST / MONITORING  ULTRASONIC SENSOR(for Front Side)  INSTALLATION  


PROCEDURE

Hide 89348 1.INSTALL NO. 1 ULTRASONIC SENSOR RETAINER

HINT:

Use the same procedure for all No. 1 ultrasonic sensor retainers.


a.
E301639C01
0.74,1.938 0.906,1.688 false 1.917,1.844 2.083,1.594 false 0.604,1.927 0.917,2.083 0.313,0.156 10 false *a 1.854,1.844 2.167,2 0.313,0.156 10 false *b
*a Cutout
*b Protrusion


Engage the 2 claws to install the No. 1 ultrasonic sensor retainer to the front bumper assembly.

NOTICE:
·

Do not damage the front bumper assembly with the protrusion when installing the No. 1 ultrasonic sensor retainer.

·

Securely install the No. 1 ultrasonic sensor retainer so that there are no gaps between the No. 1 ultrasonic sensor retainer and surface of the front bumper assembly.



HINT:

When installing the retainer, align the cutout and protrusion as shown in the illustration.



Hide 89341A 2.INSTALL NO. 1 ULTRASONIC SENSOR

HINT:

Use the same procedure for all No. 1 ultrasonic sensors.


a.

Engage the 2 claws to install the No. 1 ultrasonic sensor to the No. 1 ultrasonic sensor retainer.

NOTICE:

Push the No. 1 ultrasonic sensor retainer from the outside of the front bumper assembly when there is a gap between the No. 1 ultrasonic sensor retainer and the front bumper assembly surface. In this case, do not push on the No. 1 ultrasonic sensor.



Hide 3.INSTALL FRONT BUMPER ASSEMBLY