Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE › from 2015.04
RM2040EQ _59 Vehicle Exterior _014737 WIPER / WASHER _0075166 WASHER NOZZLE G

WIPER / WASHER  WASHER NOZZLE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85035 1.INSPECT WASHER NOZZLE SUB-ASSEMBLY

a.

Operate the washer nozzle sub-assembly and check the position that the washer fluid hits the windshield.

Standard:

Washer fluid hits the windshield in the areas shown in the illustration.


E312143C03
4.99,2.354 5.323,2.354 false 4.698,3.333 5.031,3.333 false 5.021,4.25 5.354,4.25 false 1.802,4.25 2.135,4.25 false 1.896,2.583 2.229,2.583 false 2.125,3.333 2.458,3.333 false 2.271,2.49 2.583,2.646 0.313,0.156 10 false *a 2.49,3.24 2.802,3.396 0.313,0.156 10 false *b 1.646,4.156 1.958,4.313 0.313,0.156 10 false *c 3,1.167 3.167,1.333 0.167,0.167 10 false A 4.083,1.167 4.25,1.333 0.167,0.167 10 false A 4.833,2.26 5.146,2.417 0.313,0.156 10 false *a 5.396,4.156 5.708,4.313 0.313,0.156 10 false *c 4.542,3.25 4.854,3.406 0.313,0.156 10 false *b 4.833,4.583 5,4.75 0.167,0.167 10 false B 3.198,5.677 3.365,5.844 0.167,0.167 10 false C 3.854,5.667 4.021,5.833 0.167,0.167 10 false C
*a Upper Limit *b Standard
*c Lower Limit - -


Standard Clearance
Area Measurement Area Measurement
A 300.0 mm (11.8 in.) B 145.0 mm (5.71 in.)
C 175 mm (6.89 in.) - -

HINT:

If the result is not as specified, replace the washer nozzle sub-assembly.