Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR › from 2015.04
RM2040EQ _59 Vehicle Exterior _014737 WIPER / WASHER _0075170 WASHER MOTOR A

WIPER / WASHER  WASHER MOTOR  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL RH

Hide 53851Z 2.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

a.
E226631

Remove the 3 screws and front wheel opening extension pad RH.


Hide 53875A 3.REMOVE FRONT FENDER LINER RH

a.
E312138

Remove the clip.


b.
E312139C01
1.49,2.49 1.802,2.646 0.313,0.156 10 false *a
*a 90°


Using a screwdriver, turn the pin 90 degrees counterclockwise and remove the pin hold clip.


c.
E312140C01
2.271,2.406 2.271,2.042 true 1.01,2.458 1.01,2.094 true 1.521,2.5 1.521,1.958 1.521,1.958 1.271,1.958 true 1.51,2.167 1.333,2.167 true 1.219,1.625 1.042,1.625 true 0.885,1.115 0.708,1.115 true 0.552,2.771 0.552,2.406 true 1.323,1.813 0.979,1.813 true 1.719,1.917 1.479,1.5 true 1.677,1.146 1.563,1.177 true 1.323,0.99 1.208,1.042 true 0.885,1.406 0.708,1.406 true 1.885,1.521 1.708,1.521 true 0.948,2.479 1.177,2.635 0.229,0.156 10 false *1 0.49,2.781 0.802,2.938 0.313,0.156 10 false *a 2.219,2.427 2.531,2.583 0.313,0.156 10 false *b 1.354,1.719 1.531,1.885 0.177,0.167 10 true *1 1.469,2.5 1.781,2.656 0.313,0.156 10 false *a 1.24,1.531 1.417,1.698 0.177,0.167 10 true *1 1.646,1.927 1.823,2.104 0.177,0.177 10 true *a 0.552,1.302 0.708,1.469 0.156,0.167 10 true *c 0.552,1 0.708,1.167 0.156,0.167 10 true *c 1.677,1.042 1.833,1.208 0.156,0.167 10 true *c 1.344,0.875 1.5,1.042 0.156,0.167 10 true *c 1.906,1.438 2.073,1.604 0.167,0.167 10 true *a
*1 Grommet
*a Screw
*b Bolt
*c clip


Remove the 5 screws.


d.

Remove the bolt.


e.

Remove the 4 clips, 3 grommets and front fender liner RH.

HINT:

The grommets need to be replaced with new ones because they will break when they are removed.



Hide 4.DRAIN WASHER FLUID

a.
E245824

Disconnect the washer hose from the windshield washer motor and pump assembly, and drain the washer fluid.

HINT:

Use a container to collect the washer fluid.



Hide 85310 5.REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.
E245826

Disconnect the connector.


b.

Remove the windshield washer motor and pump assembly as shown in the illustration.