Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2015.04
RM2040EQ _51 Engine / Hybrid System _014700 CRUISE CONTROL _0166042 DYNAMIC RADAR CRUISE CONTROL SYSTEM J

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  Cruise Main Indicator Light Circuit  


DESCRIPTION

When the cruise control system is turned on using the cruise control main switch (ON-OFF button), the cruise control indicator light (vehicle-to-vehicle distance control mode) illuminates. The driving support ECU assembly uses these and other indicators to indicate the control condition (presence or absence of a vehicle in front, vehicle-to-vehicle distance, and set vehicle speed) and fail-safe state through the CAN communication system.

WIRING DIAGRAM

E230010E26
1.333,0.604 1.781,0.771 0.448,0.167 10 false CANH 1.344,1.104 1.792,1.271 0.448,0.167 10 false CANL 5.531,0.594 5.979,0.76 0.448,0.167 10 false CA2H 5.531,1.094 5.979,1.26 0.448,0.167 10 false CA2L 3.938,0.594 4.385,0.76 0.448,0.167 10 false CA2H 3.958,1.104 4.406,1.271 0.448,0.167 10 false CA2L 2.979,0.594 3.427,0.76 0.448,0.167 10 false CA1H 2.979,1.104 3.427,1.271 0.448,0.167 10 false CA1L 1.792,0.427 1.99,0.583 0.198,0.156 10 false 17 1.792,0.917 2,1.125 0.208,0.208 10 false 16 4.438,0.417 4.635,0.573 0.198,0.156 10 false 35 4.438,0.906 4.635,1.063 0.198,0.156 10 false 34 2.677,0.417 2.875,0.573 0.198,0.156 10 false 25 2.677,0.906 2.875,1.063 0.198,0.156 10 false 24 5.302,0.427 5.5,0.583 0.198,0.156 10 false 39 5.292,0.917 5.49,1.073 0.198,0.156 10 false 17 2.698,0.604 2.917,0.781 0.219,0.177 10 false I4 2.698,1.104 2.917,1.281 0.219,0.177 10 false I4 4.469,0.604 4.688,0.781 0.219,0.177 10 false I3 4.469,1.094 4.688,1.271 0.219,0.177 10 false I3 0.24,1.625 0.51,1.781 0.271,0.156 10 false I18 0.219,1.781 2.052,1.969 1.833,0.188 10 false Combination Meter Assembly 3.052,1.698 4.333,2.135 1.281,0.438 10 false Power Management Control ECU 5.229,1.594 5.625,1.781 0.396,0.188 10 false I176 5.219,1.74 7.125,1.938 1.906,0.198 10 false Driving Support ECU Assembly 0.865,2.302 2.667,2.448 1.802,0.146 10 false : CAN Communication Line

CAUTION / NOTICE / HINT

HINT:

If the vehicle in front in the same lane significantly decreases vehicle speed or another vehicle moves in front of this vehicle, adequate deceleration cannot be applied by the cruise control system and the vehicle-to-vehicle distance will become shorter. At this time, the system sounds the buzzer to warn the driver. The indicators for the dynamic radar cruise control system use CAN for communication. Therefore, if there are any indicator malfunctions, check for DTCs in the CAN communication system before troubleshooting this circuit.


PROCEDURE

1.PERFORM ACTIVE TEST USING GTS (METER DISPLAY 1)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Meter Display 1 Multi-information display OFF or All -
Body Electrical > Combination Meter > Active Test
Tester Display
Meter Display 1
50004 122 7

Result:
Result Proceed to
The multi-information display in the combination meter assembly turns on or off according to the operation of the Active Test. A
The multi-information display in the combination meter assembly does not turn on or off according to the operation of the Active Test. B



A

2.READ VALUE USING GTS (CCS MAIN SW-READY)

B

2.READ VALUE USING GTS (CCS MAIN SW-READY)
a.

Enter the following menus: Powertrain / Radar Cruise / Data List.


b.

Read the Data List according to the display on the GTS.

Powertrain > Radar Cruise > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
CCS Main SW-Ready Dynamic radar cruise control system standby condition ON or OFF ON: Dynamic radar cruise control system standby
OFF: Dynamic radar cruise control system not standby
-
Powertrain > Radar Cruise > Data List
Tester Display
CCS Main SW-Ready
50003 197 115

Result:
Result Proceed to
The cruise control indicator illuminates and turns off according to the operation of the cruise control main switch (ON-OFF switch). A
The cruise control indicator does not illuminate but the Data List item CCS Main SW-Ready changes according to the operation of the cruise control main switch (ON-OFF switch). B
The cruise control indicator does not illuminate and the Data List item CCS Main SW-Ready does not change according to the operation of the cruise control main switch (ON-OFF switch). C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY

C

REPLACE DRIVING SUPPORT ECU ASSEMBLY