Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2015.04
RM2040EQ _51 Engine / Hybrid System _014700 CRUISE CONTROL _0166042 DYNAMIC RADAR CRUISE CONTROL SYSTEM J

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  Wiper Signal Circuit  


DESCRIPTION

When the driving support ECU assembly detects that the wipers are operating at high speed, control of vehicle speed by the dynamic radar cruise control system is canceled.

WIRING DIAGRAM

E234003E26
0.323,2.76 0.604,2.948 0.281,0.188 10 false I32 0.323,2.938 2.604,3.167 2.281,0.229 10 false Windshield Wiper Switch Assembly 5.156,2.719 5.5,2.948 0.344,0.229 10 false I176 5.417,1.5 5.813,1.667 0.396,0.167 10 false WIP2 5.167,1.396 5.375,1.563 0.208,0.167 10 false 32 5.146,2.885 7.125,3.083 1.979,0.198 10 false Driving Support ECU Assembly 1.969,1.385 2.177,1.552 0.208,0.167 10 false 1 1.708,1.5 1.917,1.667 0.208,0.167 10 false +2 3.615,1.656 4.333,1.823 0.719,0.167 10 false WIPER-S

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK WIPER AND WASHER SYSTEM
a.

Check the wiper and washer system operates normally.

OK:

Wiper and washer system operates normally



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER SWITCH ASSEMBLY- AUXILIARY BATTERY AND BODY GROUND)

NG

2.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER SWITCH ASSEMBLY- AUXILIARY BATTERY AND BODY GROUND)
a.
E251017C94
0.667,0.698 1.052,0.979 0.385,0.281 1.167,2.927 1.375,2.927 1.375,2.927 1.938,1.917 true 0.083,0.104 0.396,0.302 0.313,0.198 10 false *a 0.75,0.75 1.063,0.948 0.313,0.198 10 false I176 0.813,2.844 1.229,3.063 0.417,0.219 10 false WIP2
*a Front view of wire harness connector
(to Driving Support ECU Assembly)


Disconnect the I176 driving support ECU assembly connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
I176-32 (WIP2) - Body ground Power switch on (IG), windshield wiper switch Hi 11 to 14 V


Standard Resistance:
Tester Connection Condition Specified Condition
I176-25 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (DRIVING SUPPORT ECU ASSEMBLY - AUXILIARY BATTERY, BODY GROUND, WINDSHIELD WIPER MOTOR ASSEMBLY AND INT RELAY)