Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2015.04
RM2040EQ _51 Engine / Hybrid System _014700 CRUISE CONTROL _0166042 DYNAMIC RADAR CRUISE CONTROL SYSTEM D

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  OPERATION CHECK  


INPUT SIGNAL CHECK


A354241C01
3.01,2.188 3.323,2.385 0.313,0.198 10 false *a 1.604,2.729 1.917,2.927 0.313,0.198 10 false *b 0.604,2.188 0.917,2.385 0.313,0.198 10 false *d 1.656,0.438 1.969,0.635 0.313,0.198 10 false *c
*a ON/OFF
*b -/SET
*c +/RES
*d CANCEL


a.

Connect the GTS to the DLC3.


b.

Check the cruise control switch using the Data List function of the GTS (ON-OFF, -/SET, +/RES and CANCEL).



INSPECT MODE SWITCH


A306759C02
2.698,1.313 3.01,1.51 0.313,0.198 10 false *a 2.563,0.281 2.875,0.479 0.313,0.198 10 false *b
*a ON-OFF
*b MODE


a.

Turn the power switch on (IG).


b.

Turn the cruise control system on using the cruise control switch (ON-OFF button). Then push the cruise control switch to MODE for 1 second or more to change to the constant speed control mode.


c.
E224649C05
1.198,0.542 1.375,0.74 0.177,0.198 10 false *a 1.229,2.417 1.438,2.635 0.208,0.219 10 false *b
*a Cruise Control Indicator
(Vehicle-to-vehicle distance control mode)
*b Cruise Control Indicator
(Constant speed control mode)


Check that the cruise control indicator (vehicle-to-vehicle distance control mode) goes off and the cruise control indicator (constant speed control mode) illuminates.

NOTICE:

Do not push any other switches before pushing the cruise control main switch to MODE. If another switch is pushed, turn the dynamic radar cruise control system off and repeat the procedure.


HINT:

If a malfunction is detected, turn the power switch off and repeat the procedure above.




INSPECT STEERING PAD SWITCH ASSEMBLY


a.

Turn the power switch on (IG).


b.

Turn the cruise control system on using the cruise control main switch.


c.
A352584C01
2.573,1.427 2.458,1.427 2.458,1.427 2.458,1.021 true 2.615,1.354 2.927,1.552 0.313,0.198 10 false *1
*1 Distance Control Switch


Press the steering pad switch assembly (distance control switch).


d.

Check that the indication of the vehicle-to-vehicle distance, which is shown on the multi-information display in the combination meter assembly, changes from long to middle to short in that order.

A340302C01
0.917,0.292 1.229,0.49 0.313,0.198 10 false *a 3.542,0.302 3.854,0.5 0.313,0.198 10 false *b 6.135,0.313 6.448,0.51 0.313,0.198 10 false *c
*a Long *b Middle
*c Short - -


HINT:

Long is automatically selected each time the power switch is turned on (READY).