Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2015.04
RM2040EQ _51 Engine / Hybrid System _014700 CRUISE CONTROL _0166042 DYNAMIC RADAR CRUISE CONTROL SYSTEM J

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  Millimeter Wave Radar Sensor Power Source Circuit  


DESCRIPTION

When the power switch is turned on (IG), auxiliary battery voltage is applied to terminal IGB of the millimeter wave radar sensor assembly.

This circuit provides power to the millimeter wave radar sensor assembly. The millimeter wave radar sensor assembly emits radio waves towards an object in front and measures the distance and direction of the object by receiving the beam reflections. Based on the reflections, the sensor calculates the difference in speed between the vehicle and the object in front. This data is transmitted to the driving support ECU assembly.

WIRING DIAGRAM

E259147E19
4.063,2.094 4.417,2.385 0.354,0.292 10 false A76 4.979,1.51 5.448,1.667 0.469,0.156 10 false SGND 4.979,0.469 5.333,0.625 0.354,0.156 10 false IGB 4.75,1.354 4.865,1.51 0.115,0.156 10 false 1 4.75,0.313 4.865,0.469 0.115,0.156 10 false 5 4.063,2.26 6.594,2.458 2.531,0.198 10 false Millimeter Wave Radar Sensor Assembly 2.438,0.615 3.417,0.802 0.979,0.188 10 false ECU-IG1 NO. 3 0.448,0.458 1.406,0.823 0.958,0.365 10 false from IG1 NO. 3 Relay

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK TERMINAL VOLTAGE (MILLIMETER WAVE RADAR SENSOR ASSEMBLY - AUXILIARY BATTERY AND BODY GROUND)
a.
C319199C16
1.5,0.24 1.927,0.5 0.427,0.26 2.031,1.146 2.396,0.667 2.396,0.667 2.615,0.667 true 1.354,1.146 0.938,0.656 0.938,0.656 0.75,0.656 true 0.125,0.115 0.438,0.313 0.313,0.198 10 false *a 1.604,0.292 2.063,0.49 0.458,0.198 10 false A76 0.333,0.583 0.792,0.781 0.458,0.198 10 false SGND 2.677,0.573 3.135,0.771 0.458,0.198 10 false IGB
*a Front view of wire harness connector
(to Millimeter Wave Radar Sensor Assembly)


Disconnect the A76 millimeter wave radar sensor assembly connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A76-5 (IGB) - Body ground Power switch on (IG) 11 to 14 V
A76-5 (IGB) - Body ground Power switch off Below 1 V


Standard Resistance:
Tester Connection Condition Specified Condition
A76-1 (SGND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR