Home › Engine / Hybrid System › CRUISE CONTROL › LANE RECOGNITION CAMERA SENSOR › from 2015.04
RM2040EQ _51 Engine / Hybrid System _014700 CRUISE CONTROL _0166044 LANE RECOGNITION CAMERA SENSOR A

CRUISE CONTROL  LANE RECOGNITION CAMERA SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

When replacing the windshield glass of a vehicle equipped with a lane departure warning camera, make sure to use a Toyota genuine part. If a non-Toyota genuine part is used, the lane departure warning camera may not be able to be installed due to a missing bracket or the lane departure alert system may not operate properly due to a difference in the transmissivity or black ceramic border.


PROCEDURE

Hide 86466C 1.REMOVE NO. 2 LANE DEPARTURE WARNING CAMERA COVER

a.
E313312

Disengage the 3 claws and 2 guides to remove the No. 2 lane departure warning camera cover as shown in the illustration.

NOTICE:

Detaching the claws one at a time may cause them to become damaged. Therefore, even if one of the claws is detached, make sure to reattach it before detaching both claws at the same time.



Hide 86466 2.REMOVE NO. 1 LANE DEPARTURE WARNING CAMERA COVER

a.
E313310

Pull the No. 1 lane departure warning camera cover as shown in the illustration to disengage the 2 clips and 2 guides, and remove the No. 1 lane departure warning camera cover.


Hide 86468 3.REMOVE LANE DEPARTURE WARNING CAMERA

a.
E313311N01
1.635,3.823 1.792,4.021 0.156,0.198 10 false 2 2.552,3.542 2.708,3.74 0.156,0.198 10 false 1

Disconnect the connector.


b.

Disengage the 3 guides and remove the lane departure warning camera as indicated by the arrows, in the order shown in the illustration.

NOTICE:
·

Do not pull the harness forcibly when disconnecting the connector.

·

If the lane departure warning camera bracket is deformed or damaged, replace it together with the windshield glass.

·

If the lane departure warning camera is dropped, replace it with a new one.