Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SWITCH › from 2015.04
RM2040EQ _51 Engine / Hybrid System _014700 CRUISE CONTROL _0166047 LANE DEPARTURE ALERT SWITCH G

CRUISE CONTROL  LANE DEPARTURE ALERT SWITCH  INSPECTION  


PROCEDURE

Hide 84978 1.INSPECT LANE DEPARTURE ALERT SWITCH (LANE-KEEPING ASSIST MAIN SWITCH)

a.

Check the switch function.

i.
B374480C02
1.188,1.74 1.479,1.333 false 2.188,1.75 1.927,1.333 false 0.344,0.25 0.656,0.448 0.313,0.198 10 false *a 1.042,1.771 1.5,1.969 0.458,0.198 10 false ECU 2.083,1.771 2.542,1.969 0.458,0.198 10 false GND
*a Component without harness connected
Lane Departure Alert Switch (Lane-keeping Assist Main Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
6 (ECU) - 3 (GND) Lane departure alert switch (lane-keeping assist main switch) on Below 1 Ω
6 (ECU) - 3 (GND) Lane departure alert switch (lane-keeping assist main switch) off 10 kΩ or higher




b.

Check that the switch illuminates.

i.
B374480C03
1.375,1.75 1.625,1.333 false 2.021,1.75 1.792,1.333 false 1.26,1.781 1.698,2 0.438,0.219 10 false ILL+ 1.979,1.781 2.417,2 0.438,0.219 10 false ILL- 0.354,0.25 0.667,0.448 0.313,0.198 10 false *a
*a Component without harness connected
Lane Departure Alert Switch (Lane-keeping Assist Main Switch)


Apply auxiliary battery voltage to the lane departure alert switch (lane-keeping assist main switch) and check that the switch illuminates.

OK:
Connection Specified Condition
Auxiliary battery positive (+) → Terminal 5 (ILL+)
Auxiliary battery negative (-) → Terminal 4 (ILL-)
Illuminates


If the result is not as specified, replace the lane departure alert switch (lane-keeping assist main switch).