Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › from 2015.04
RM2040EQ _58 Vehicle Interior _035749 PRE-CRASH SAFETY _0166048 PRE-CRASH SAFETY SYSTEM D

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  DIAGNOSIS SYSTEM  



FUNCTION OF WARNING INDICATOR AND MESSAGE


a.

If the pre-crash safety system is not functioning properly, the driver is warned by the PCS warning indicator and a warning message on the multi-information display in the combination meter assembly.

Master Warning Indicator Warning Message Detail DTC PCS Warning Indicator
ON Check Pre-Crash Safety This message is displayed when the driving support ECU assembly detects a system malfunction ○ Flashes
OFF Pre-Crash Safety Temporarily Not Available This message is displayed when the driving support ECU assembly is in fail-safe mode
Click here(Click here)
- Flashes


b.

Initial check

i.

The initial check occurs when the power switch is off for more than 2 seconds, and then turned on (IG). The initial check consists of a pre-crash safety system diagnostic check with a duration of approximately 3 seconds.


ii.

If a malfunction is detected during the initial check, the multi-information display will display "Check Pre-Crash Safety" or "Pre-Crash Safety Temporarily Not Available".



c.

Constant check

i.

The driving support ECU assembly constantly monitors the pre-crash safety system for malfunctions after the power switch is turned on (IG) and the initial check (approximately 3 seconds) has completed.


ii.

"Check Pre-Crash Safety" or "Pre-Crash Safety Temporarily Not Available" is displayed on the multi-information display in the combination meter assembly when the constant check detects malfunctions in the pre-crash safety system.