Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM CANCEL SWITCH › from 2015.04
RM2040EQ _58 Vehicle Interior _035749 PRE-CRASH SAFETY _0166049 PRE-CRASH SAFETY SYSTEM CANCEL SWITCH G

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM CANCEL SWITCH  INSPECTION  


PROCEDURE

Hide 84770A 1.INSPECT PRE-CRASH SYSTEM CANCEL SWITCH ASSEMBLY

a.

Check the switch function.

i.
E315532C01
0.604,0.302 0.927,0.521 0.323,0.219 10 false *a
*a Component without harness connected
(Pre-crash System Cancel Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
5 - 8 Pressed Below 1 Ω
Not pressed 10 kΩ or higher




b.

Check that the switch illuminates.

i.

Apply auxiliary battery voltage to the pre-crash system cancel switch assembly and check that the switch illuminates.

OK:
Battery Connection Specified Condition
Auxiliary battery positive (+) → 7
Auxiliary battery negative (-) → 6
Illuminates


If the result is not as specified, replace the pre-crash system cancel switch assembly.