OVERALL CAN BUS DIAGRAM
The CAN communication system is composed of 4 buses.
| 1 | Combination Meter Assembly
(for V Bus) |
2 | Airbag Sensor Assembly
(for V Bus) |
| 3 | Main Body ECU (Multiplex Network Body ECU)
(for V Bus and Sub Bus 1) |
4 | Air Conditioning Amplifier Assembly
(for V Bus) |
| 5 | Power Steering ECU Assembly
(for V Bus) |
6 | Steering Sensor
(for V Bus) |
| 7 | DLC3
(for V Bus) |
8 | Radio and Display Receiver Assembly
(for Radio and Display Type) (for V Bus) |
| 9 | Navigation ECU Sub-assembly
(for Navigation Receiver Type with HDD) (for V Bus) |
10 | Navigation Receiver Assembly
(for Navigation Receiver Type without HDD) (for V Bus) |
| 11 | Smart Key ECU Assembly (Certification ECU)
(for V Bus) |
12 | Power Management Control ECU
(for V Bus, Sub Bus 11 and Sub Bus 15) |
| 13 | Headlight Swivel ECU Assembly (AFS ECU)
(w/ Automatic High Beam System) (for V Bus) |
14 | Brake Booster with Master Cylinder Assembly (Skid Control ECU)
(for V Bus and Sub Bus 15) |
| 15 | ECM
(for V Bus and Sub Bus 15) |
16 | Outer Mirror Control ECU Assembly (for Front Passenger Side)
(w/ Seat Position Memory System) (for Sub Bus 1) |
| 17 | CAN Junction RH2 Connector
(w/ Seat Position Memory System) (for Sub Bus 1) |
18 | Outer Mirror Control ECU Assembly (for Driver Side)
(w/ Seat Position Memory System) (for Sub Bus 1) |
| 19 | Position Control ECU and Switch Assembly (for Driver Side)
(w/ Seat Position Memory System) (for Sub Bus 1) |
20 | CAN No. 4 Junction Connector
(for Sub Bus 11) |
| 21 | Blind Spot Monitor Sensor LH
(w/ Blind Spot Monitor System) (for Sub Bus 11) |
22 | Blind Spot Monitor Sensor RH
(w/ Blind Spot Monitor System) (for Sub Bus 11) |
| 23 | Rear Television Camera Assembly
(w/ Parking Assist Monitor System without Parallel Parking Assist Function) (for Sub Bus 11) |
- | - |
The main body ECU (multiplex network body ECU) functions as a gateway between the V bus and sub bus 1.
The power management control ECU functions as a gateway between the V bus and sub bus 11.
Refer to the following bus wiring diagrams for details.
V BUS
The CAN communication system connects to other networks via ECUs that function as a gateway.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>SYSTEM DIAGRAM
SUB BUS 1 (w/ Seat Position Memory System)
SUB BUS 11
SUB BUS 15