Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM › from 2015.04
RM2040EQ _59 Vehicle Exterior _014738 LIGHTING (EXT) _0075174 AUTOMATIC HIGH BEAM SYSTEM D

LIGHTING (EXT)  AUTOMATIC HIGH BEAM SYSTEM  DIAGNOSIS SYSTEM  


DESCRIPTION


a.

Automatic high beam system data and the Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.




INSPECT AUXILIARY BATTERY VOLTAGE


a.

Measure the auxiliary battery voltage with the power switch off.

Standard Voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the auxiliary battery.



DIAGNOSIS SYSTEM


a.

If the automatic high beam system malfunctions, the automatic high beam indicator light turns off and "Check Headlight System" is displayed on the multi-information display.

HINT:
·

In this case, the main body ECU (multiplex network body ECU) stores DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>DTC CHECK / CLEAR

·

When the system returns to normal, the "Check Headlight System" is no longer displayed on the multi-information display.