OVERALL CAN BUS DIAGRAM
The CAN communication system is composed of 5 buses.
| 1 | Combination Meter Assembly
(for V Bus) |
2 | Airbag Sensor Assembly
(for V Bus) |
| 3 | Main Body ECU (Multiplex Network Body ECU)
(for V Bus and Sub Bus 1) |
4 | Air Conditioning Amplifier Assembly
(for V Bus) |
| 5 | Power Steering ECU Assembly
(for V Bus) |
6 | Steering Sensor
(for V Bus) |
| 7 | DLC3
(for V Bus) |
8 | Radio and Display Receiver Assembly
(for Radio and Display Type) (for V Bus) |
| 9 | Navigation Receiver Assembly
(for Navigation Receiver Type) (for V Bus) |
10 | Smart Key ECU Assembly (Certification ECU)
(for V Bus) |
| 11 | Power Management Control ECU
(for V Bus, Sub Bus 11 and Sub Bus 15) |
12 | Clearance Warning ECU Assembly
(w/ Toyota Parking Assist-sensor System) (for V Bus) |
| 13 | Brake Booster with Master Cylinder Assembly (Skid Control ECU)
(for V Bus and Sub Bus 15) |
14 | ECM
(for V Bus and Sub Bus 15) |
| 15 | Outer Mirror Control ECU Assembly (for Front Passenger Side)
(w/ Seat Position Memory System) (for Sub Bus 1) |
16 | CAN Junction RH2 Connector
(w/ Seat Position Memory System) (for Sub Bus 1) |
| 17 | Outer Mirror Control ECU Assembly (for Driver Side)
(w/ Seat Position Memory System) (for Sub Bus 1) |
18 | Position Control ECU and Switch Assembly (for Driver Side)
(w/ Seat Position Memory System) (for Sub Bus 1) |
| 19 | CAN No. 4 Junction Connector
(for Sub Bus 11) |
20 | Blind Spot Monitor Sensor RH
(w/ Blind Spot Monitor System) (for Sub Bus 11) |
| 21 | Lane Departure Warning Camera
(w/ Lane Departure Alert System) (for Sub Bus 11) |
22 | Driving Support ECU Assembly
(w/ Pre-crash Safety System) (for Sub Bus 11 and Sub Bus 13) |
| 23 | Rear Television Camera Assembly
(w/ Parking Assist Monitor System without Parallel Parking Assist Function) (for Sub Bus 11) |
24 | Millimeter Wave Radar Sensor Assembly
(w/ Pre-crash Safety System) (for Sub Bus 13) |
The main body ECU (multiplex network body ECU) functions as a gateway between the V bus and sub bus 1.
The power management control ECU functions as a gateway between the V bus and sub bus 11.
The driving support ECU assembly functions as a gateway between the sub bus 11 and sub bus 13.
Refer to the following bus wiring diagrams for details.
V BUS
The CAN communication system connects to other networks via ECUs that function as a gateway.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>SYSTEM DIAGRAM
SUB BUS 1 (w/ Seat Position Memory System)
SUB BUS 11
SUB BUS 13 (w/ Pre-crash Safety System)
SUB BUS 15