Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › from 2015.04
RM2040EQ _59 Vehicle Exterior _014740 EXTERIOR PANELS / TRIM _0075202 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  REMOVAL  


PROCEDURE

Hide 53295E 1.REMOVE COOL AIR INTAKE DUCT SEAL

a.
B402801

Remove the 9 clips and cool air intake duct seal.


Hide 2.REMOVE FRONT BUMPER ASSEMBLY

a.
B402802C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the front bumper assembly as shown in the illustration.


b.
B381229

Remove the 7 screws.


c.
B381224C01
2.104,2.24 2.104,2.073 true 2.042,2.24 2.313,2.51 0.271,0.271 10 false *1 3.083,2.188 3.406,2.49 0.323,0.302 10 false *a
*1 Pin Hold Clip
*a 90°


Using a screwdriver, turn the pins 90 degrees and remove the pin hold clip.

HINT:

Use the same procedure for the RH side and LH side.



d.

Remove the clip.

HINT:

Use the same procedure for the RH side and LH side.



e.
B402803C01
1.802,3.688 2.375,3.573 true 1.604,3.615 1.906,3.802 0.302,0.188 10 false *a
*a Screwdriver
V100155

Protective Tape


Using a screwdriver with its tip wrapped with protective tape, disengage the 3 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



f.

Pull back the side of the front bumper assembly and disconnect each connector.

NOTICE:

Do not apply excessive force when separating the front bumper assembly.



g.
B402804

Using a clip remover, remove the clip and 2 hood center cushions.


h.
B402805

Remove the 2 bolts.


i.
B402806

Remove the front bumper assembly as shown in the illustration.