52164A
1.REMOVE REAR BUMPER PLATE LH
| *a | Hook |
|
Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws.
Disengage the hook and remove the rear bumper plate LH.
52163A
2.REMOVE REAR BUMPER PLATE RH
Use the same procedure as for the LH side.
3.REMOVE REAR BUMPER ASSEMBLY
|
Protective Tape |
Apply protective tape around the rear bumper assembly as shown in the illustration.
Remove the 2 screws.
|
Screw |
|
Clip |
Remove the 5 screws.
Using a clip remover, remove the 4 clips.
Remove the screw.
Use the same procedure for the RH side and LH side.
| *a | Screwdriver |
|
Protective Tape |
Disengage the claw (A).
Use the same procedure for the RH side and LH side.
Using a screwdriver with its tip wrapped with protective tape, disengage the 6 claws (B) as shown in the illustration.
Use the same procedure for the RH side and LH side.
Disengage the 6 claws as shown in the illustration.
w/ TOYOTA Parking Assist-sensor System:
Disengage the 3 clamps (w/ Corner Sensor).
Disconnect the connector.
Remove the rear bumper assembly.