Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER › from 2015.04
RM2040EQ _59 Vehicle Exterior _014740 EXTERIOR PANELS / TRIM _0075191 REAR BUMPER A

EXTERIOR PANELS / TRIM  REAR BUMPER  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE NO. 2 LUGGAGE ROOM WIRE (w/ TOYOTA Parking Assist-sensor System)

Hide 89348J 2.REMOVE ULTRASONIC SENSOR CLIP (w/ TOYOTA Parking Assist-sensor System)

Hide 89341A 3.REMOVE NO. 1 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)

Hide 89348 4.REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)

Hide 5.REMOVE REAR BUMPER LOWER COVER

a.
B381262

Remove the 2 outside moulding retainers.


b.

Remove the 2 clips.


c.

Disengage the 10 claws and 2 guides, and remove the rear bumper lower cover.

B381263


Hide 52576 6.REMOVE REAR BUMPER SIDE RETAINER LH

a.
B401580

Using a screwdriver, disengage the 3 clips as shown in the illustration.


b.

Disengage the 3 claws to remove the rear bumper side retainer LH.


Hide 52575 7.REMOVE REAR BUMPER SIDE RETAINER RH

HINT:

Use the same procedure as for the LH side.


Hide 8.REMOVE REAR BUMPER SIDE SEAL LH

a.
B381252

Remove the grommet.


b.

Remove the 2 screws.


c.
B381253

Disengage the guide and claw to remove the rear bumper side seal LH.


Hide 9.REMOVE REAR BUMPER SIDE SEAL RH

HINT:

Use the same procedure as for the LH side.


Hide 52023 10.REMOVE REAR BUMPER REINFORCEMENT SUB-ASSEMBLY

a.
B403613

w/o Corner Sensor:

i.

Remove the 6 nuts and rear bumper reinforcement sub-assembly.



b.
B402816

w/ Corner Sensor:

i.

Remove the 6 nuts and rear bumper reinforcement sub-assembly.