1.INSTALL REAR BUMPER ASSEMBLY
w/ TOYOTA Parking Assist-sensor System:
Connect the connector.
Engage the 3 clamps (w/ Corner Sensor).
Engage the 6 claws as shown in the illustration.
Engage the 7 claws as shown in the illustration.
Use the same procedure for the RH side and LH side.
Install the screw.
Use the same procedure for the RH side and LH side.
Install the 4 clips.
Install the 5 screws.
Install the rear bumper assembly with the 2 screws.
52164A
2.INSTALL REAR BUMPER PLATE LH
| *a | Hook |
Engage the hook.
Engage the 2 claws to install the rear bumper plate LH.
52163A
3.INSTALL REAR BUMPER PLATE RH
Use the same procedure as for the LH side.