FREEZE FRAME DATA
Whenever a meter DTC is detected, the combination meter assembly stores the current vehicle state as freeze frame data.
CHECK FREEZE FRAME DATA
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Trouble Codes.
According to the GTS display, select a DTC that stored freeze frame data.
Read the freeze frame data recorded when the DTC was stored.
| Tester Display | Condition | Displayed Item |
|---|---|---|
| B1507 | Open in Turn Signal Circuit | ·
TRIP ·
Elapsed time after power switch on (IG) |
| B1508 | Short in Turn Signal / Hazard Flasher Circuit | |
| B150A*1, *4 | Lost Communication with HMI-LAN | |
| U0100 | Lost Communication with ECM / PCM "A" | |
| U0129 | Lost Communication with Brake System Control Module | |
| U0131 | Lost Communication with Power Steering Control | |
| U0142 | Lost Communication with Body Control Module "B" | |
| U0151 | Lost Communication with Restraints Control Module | |
| U0163*1 | Lost Communication with Navigation Control Module | |
| U023A*2 | Lost Communication with Front Camera Module | |
| U1104*3 | Lost Communication with Driving Support ECU |
*1: for Navigation Receiver Type
*2: w/ Lane Departure Alert System
*3: w/ Pre-crash Safety System
*4: for Radio and Display Type
CLEAR FREEZE FRAME DATA
Clearing the DTCs will also clear the freeze frame data.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Clear DTCs and freeze frame data.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR