DATA LIST
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Warm up the engine.
Turn the power switch off.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus:
for Combination Meter: Body Electrical / Combination Meter / Data List.
for ABS/VSC/TRC: Chassis / ABS/VSC/TRC / Data List.
for Engine and ECT: Powertrain / Engine and ECT / Data List.
for Main Body: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| ODO/TRIP Change SW | ODO/TRIP change switch | OFF or ON | OFF: Switch released
ON: Switch pushed |
- |
| P-Seatbelt Buckle SW | Front passenger seat belt buckle switch | OFF or ON | OFF: Front passenger seat belt fastened (warning light off)
ON: Front passenger seat belt unfastened (warning light on) |
- |
| Vehicle Speed Meter | Vehicle speed | Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) | Almost the same as actual vehicle speed | - |
| Engine Rpm | Engine speed | Min.: 0 rpm, Max.: 12750 rpm | Almost the same as actual engine speed | - |
| Coolant Temperature | Engine coolant temperature | Min.: 0°C (32°F), Max.: 127.5°C (261.5°F) | After warming up: 75 to 100°C (167 to 212°F) | - |
| Check Engine SW | MIL (Check engine warning light) | OFF or ON | OFF: MIL (Check engine warning light) off
ON: MIL (Check engine warning light) on |
- |
| Light Control Switch | Light control switch | OFF or ON | OFF: Switch released
ON: Switch pushed |
- |
| +B Voltage Value | Auxiliary battery voltage | Min.: 0 V, Max.: 25.5 V | 11 to 14 V | - |
| Fuel Input | Fuel input | Min.: 0 L, Max.: 127.5 L | Fuel receiver gauge indicates F: 57.0
Fuel receiver gauge indicates 3/4: 46.5 Fuel receiver gauge indicates 1/2: 31.6 Fuel receiver gauge indicates 1/4: 14.8 Fuel receiver gauge indicates E: 5.5 |
Unit: Liter |
| Ambient Temperature | Outside temperature | Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F) | Almost the same as actual outside temperature | The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F) |
| HV System Indicator | Hybrid system indicator value | Min.: -512%, Max.: 511% | -512 to 511% | - |
| Multi Switch (Up) | Steering pad switch (Up) | OFF or ON | OFF: Switch released
ON: Switch pushed |
- |
| Multi Switch (Down) | Steering pad switch (Down) | OFF or ON | OFF: Switch released
ON: Switch pushed |
- |
| Multi Switch (Enter) | Steering pad switch (Enter) | OFF or ON | OFF: Switch released
ON: Switch pushed |
- |
| Multi Switch (Right) | Steering pad switch (Page) | OFF or ON | OFF: Switch released
ON: Switch pushed |
- |
| 2nd-Row Seatbelt Buckle (R) | Rear seat belt buckle switch RH | OFF or ON | OFF: Rear seat belt RH fastened
ON: Rear seat belt RH unfastened |
- |
| 2nd-Row Seatbelt Buckle (L) | Rear seat belt buckle switch LH | OFF or ON | OFF: Rear seat belt LH fastened
ON: Rear seat belt LH unfastened |
- |
| 2nd-Row Seatbelt Buckle (C) | Rear seat belt buckle switch center | OFF or ON | OFF: Rear seat belt center fastened
ON: Rear seat belt center unfastened |
- |
| Oil Pressure Switch | Oil pressure switch | OFF or ON | OFF: Engine started
ON: Engine not started |
- |
| Turn Signal Switch (Right) | RH turn signal switch | OFF or ON | OFF: RH turn signal switch off
ON: RH turn signal switch on |
- |
| Turn Signal Switch (Left) | LH turn signal switch | OFF or ON | OFF: LH turn signal switch off
ON: LH turn signal switch on |
- |
| Hazard Flasher Switch | Hazard warning switch | OFF or ON | OFF: Switch released
ON: Switch pushed |
- |
| Multi Switch (Back) | Steering pad switch (Back) | OFF or ON | OFF: Switch released
ON: Switch pushed |
- |
| Key Remind Sound | Cycle of the key reminder warning buzzer | Normal, Slow, Fast | Displays customize setting of Key Remind Sound | - |
| Driver Side Seatbelt Warning Buzzer | Setting of the driver seat belt warning buzzer | OFF or ON | OFF: Seat belt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when driver seat belt unfastened
ON: Seat belt warning buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when driver seat belt unfastened |
Displays customize setting of Driver Side Seatbelt Warning Buzzer |
| P-Seatbelt Warning Buzzer | Setting of the front passenger seat belt warning buzzer | OFF or ON | OFF: Seat belt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when front passenger seat belt unfastened
ON: Seat belt warning buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when front passenger seat belt unfastened |
Displays customize setting of Front Passenger Side Seatbelt Warning Buzzer |
| Rear Seatbelt Warning Buzzer | Setting of the rear seat belt warning buzzer | OFF or ON | OFF: Seat belt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when rear seat belt unfastened
ON: Seat belt warning buzzer sounds at vehicle speed of 20km/h (12 mph) or more when rear seat belt unfastened |
Displays customize setting of Rear Seat Belt Warning Buzzer |
| Flasher Sound Volume Adjustment | Setting of the flasher sound volume adjustment | Small, Medium, Large | Displays customize setting of Flasher Sound Volume Adjustment | - |
| PCS System | Existence of function | With or Without | With: w/ Pre-crash Safety System
Without: w/o Pre-crash Safety System |
- |
| Radar Cruise System | Existence of function | With or Without | With: w/ Dynamic Radar Cruise Control System
Without: w/o Dynamic Radar Cruise Control System |
- |
| Number of Trouble Code | The number of DTCs currently stored | Min.: 0, Max.: 255 | 0 | - |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Vehicle Speed | Vehicle speed | Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Coolant Temp | Engine coolant temperature | Min.: -40°C (-40°F), Max.: 140°C (284°F) | 75 to 100°C (167 to 212°F): After warming up | ·
Stored as Freeze Frame Data ·
This is the engine coolant temperature.
|
Enter inspection mode (See page General>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE).
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Illumination Rate Info | Illumination rate information | 0 ms to 2162.65 ms | Value output according to ambient light level | - |
ACTIVE TEST
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Perform the Active Test according the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Speed Meter Operation | Speedometer | 0, 40, 80, 120, 160, 200, 240 km/h | There is a deviation in the values displayed on the speedometer (Control range → Speedometer display)
·
40 → 41.4 to 45.9 ·
80 → 82.8 to 87.8 ·
120 → 124.1 to 129.1 ·
160 → 165.5 to 170.5 ·
200 → 206.9 to 211.9 |
| Fuel Meter Operation | Fuel receiver gauge | OFF, Sender E, Empty, Warning, 1/4, 1/2, 3/4, Full, Sender F | - |
| A/T Indicator Operation 1 | Shift position indicator | OFF, D, N, R, P | - |
| A/T Indicator Operation 2 | Shift position indicator | OFF, B | - |
| Indicat. Lamp Airbag | SRS warning light | OFF or ON | - |
| Driver Side Seat Belt | Driver or front passenger seat belt warning light | OFF or ON | - |
| Indicat. Lamp ABS | ABS warning light | OFF or ON | - |
| Indicat. Lamp Slip | Slip indicator light | OFF or ON | - |
| Indicat. Lamp Beam | High beam indicator light | OFF or ON | - |
| Indicat. Lamp Tail | Tail indicator light | OFF or ON | - |
| Indicat. Precrash | PCS OFF warning light | OFF or ON | *1 |
| Indicat. Lamp Fuel | Fuel level warning light | OFF or ON | - |
| Indicat. Lamp ECB | Brake warning light / yellow (minor malfunction) | OFF or ON | - |
| Indicat. Lamp Brake | Brake warning light / red (malfunction) | OFF or ON | - |
| Indicat. EPS | EPS warning light | OFF or ON | - |
| Master Warning | Master warning light | OFF or ON | - |
| Indicat. Ready (HV) | READY indicator light | OFF or ON | - |
| Indicat. VSC OFF | VSC OFF indicator light | OFF or ON | - |
| Rear Seat Belt | Rear seat belt indicator light | OFF or ON | - |
| Automatic High Beam Indicator | Automatic high beam indicator light | OFF or ON | *2 |
| EV Mode Indicator | EV indicator light | OFF or ON | - |
| Turn Signal (Left) Indicator | LH turn indicator light | OFF or ON | - |
| Turn Signal (Right) Indicator | RH turn indicator light | OFF or ON | - |
| Check Engine Indicator | MIL (Check engine warning light) | OFF or ON | - |
| Water Temperature Meter Operation | Engine coolant temperature receiver gauge | OFF, LOW, NORMAL, HIGH | - |
| HV System Indicator | Hybrid system indicator | OFF, MIN, -50, 0, 100, 200, 300, 400, MAX | - |
| Meter Display 1 | Multi-information display | OFF, All | - |
*1: w/ Pre-crash Safety System
*2: w/ Automatic High Beam System