Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2015.04
RM2040EQ _58 Vehicle Interior _014725 METER / GAUGE / DISPLAY _0075073 METER / GAUGE SYSTEM G

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 83100 1.INSPECT COMBINATION METER ASSEMBLY

a.

INSPECT SPEEDOMETER

NOTICE:
·

The combination meter assembly receives the vehicle speed signal from the brake booster with master cylinder assembly (skid control ECU) via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the brake booster with master cylinder assembly (skid control ECU) because it is the source of the vehicle speed signal.

·

The Data List values of the brake booster with master cylinder assembly (skid control ECU) are used for this inspection. Therefore, make sure to perform the inspection after confirming that no DTCs are output from the electronically controlled brake system.

·

If the tire size or tire inflation pressure is not within the specified range, or the tires are excessively worn, the speedometer indication error will increase. Therefore, make sure to perform the inspection after checking that the tire size, tire inflation pressure and tire wear are in the specified range.



i.

Before starting the following inspection, check if electronically controlled brake system DTCs are output.


ii.

Read the Data List according to the display on the GTS.

Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Vehicle Speed Maximum wheel speed sensor reading Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
Chassis > ABS/VSC/TRC > Data List
Tester Display
Vehicle Speed
50003 105 42
Reference: km/h
GTS Indication (km/h) Acceptable Range (km/h)
20 20.7 to 24.7
40 41.4 to 45.9
60 62.1 to 66.6
80 82.8 to 87.8
100 103.4 to 107.4
120 124.1 to 129.1
140 144.8 to 149.8
160 165.5 to 170.5
180 186.2 to 191.2
200 206.9 to 211.9
220 227.6 to 232.6



b.

CHECK LED ILLUMINATION (BULB CHECK)

i.

Check the illumination function of the warning or indicator lights listed below when turning the power switch on (IG).

OK:
Warning or Indicator Light Specified Condition
Brake warning light / red (malfunction)
·

Warning light or indicator light comes on for about 3 seconds after turning the power switch on (IG).

·

Warning light or indicator light comes on when turning the power switch from off to on (READY) for 3 seconds, then goes off.


Brake warning light / yellow (minor malfunction)
Slip indicator light
ABS warning light
VSC OFF indicator light
PCS OFF warning light*
Master warning light Warning light comes on for about 3 seconds after turning the power switch on (IG).
SRS warning light Warning light comes on for about 6 seconds after turning the power switch on (IG).
MIL (Check engine warning light) Warning light comes on when turning the power switch on (IG).
EPS warning light


*: w/ Pre-crash Safety System