Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BODY SIDE PANEL PROTECTOR › from 2015.04
RM2040EQ _59 Vehicle Exterior _014740 EXTERIOR PANELS / TRIM _0168152 REAR BODY SIDE PANEL PROTECTOR A

EXTERIOR PANELS / TRIM  REAR BODY SIDE PANEL PROTECTOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 75056B 1.INSTALL REAR OUTER PILLAR GARNISH SUB-ASSEMBLY

HINT:

When installing the rear outer pillar garnish sub-assembly, heat the vehicle body and rear outer pillar garnish sub-assembly using a heat light.


Heating Temperature
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Rear Outer Pillar Garnish Sub-assembly 20 to 30°C (68 to 86°F)

NOTICE:

Do not heat the vehicle body, rear outer pillar garnish sub-assembly excessively.


a.

Clean the vehicle body surface.

i.

Using a heat light, heat the vehicle body surface.


ii.

Remove any remaining double-sided tape from the vehicle body.


iii.

Wipe off any tape adhesive residue with cleaner.



b.

Using a heat light, heat the vehicle body and a new rear outer pillar garnish sub-assembly.


c.

Remove the release paper from the rear outer pillar garnish sub-assembly.

HINT:

After removing the release paper, keep the exposed adhesive free from foreign matter.



d.
B401432C01
0.885,0.583 1.146,0.469 true 0.688,0.521 1,0.813 0.313,0.292 10 false *a
*a Double-sided Tape


Engage the 6 clips and install the rear outer pillar garnish sub-assembly.