CUSTOMIZE TOYOTA PARKING ASSIST-SENSOR SYSTEM
Customizing with the GTS
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the back sonar or clearance sonar switch assembly on.
Turn the GTS on.
Enter the following menus: Body Electrical / Clearance Sonar / Utility / Customize Setting.
Select the setting by referring to the table below.
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Keep Sense Buzzer | Sounds the buzzer when the distance between the vehicle and obstacle does not change for more than 3 seconds. | Avail | 0:Not Avail,1:Avail | Clearance warning ECU assembly |
| Fr & Rr Buzzer Volume | Changes the buzzer volume setting. | H | 001:L,010:M1,011:M2,100:M3,101:H | Clearance warning ECU assembly |
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Sensor Condition N | Makes the front sensors available when the shift lever is in N. | Avail | 0:Not Avail,1:Avail | Clearance warning ECU assembly |
| Reverse Range Front Sensor | Changes the operation setting for the front sensors when the shift lever is in R. | F | 0:F,1:F Stop | Clearance warning ECU assembly |
| Non P/R Range Rear Sensor | Changes the operation setting for the rear sensors when the shift lever is in any position other than P or R. | R Stop | 0:R,1:R Stop | Clearance warning ECU assembly |