These DTCs are stored when the clearance warning ECU assembly cannot receive and recognize several signals via the CAN communication system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0100 | Lost Communication with ECM / PCM "A" | Lost communication with the ECM(RM19V3EQ)(RM2033EQ)(RM2123EL)
Lost communication with the power management control ECU(RM2043EQ) |
CAN communication system |
| U0101 | Lost Communication with TCM | Lost communication with the ECM(RM19V3EQ)(RM2033EQ)(RM2123EL)
Lost communication with the power management control ECU(RM2043EQ) |
CAN communication system |
| U0142 | Lost Communication with Body Control Module "B" | Lost communication with the main body ECU (multiplex network body ECU) | CAN communication system |
| U0155 | Lost Communication with Instrument Panel Cluster Control Module (Combination Meter) | Lost communication with the combination meter assembly | CAN communication system |
When 2 or more DTCs starting with "U" are output simultaneously, inspect the connectors and wire harnesses of each ECU.
Clear the DTCs.
Check for DTCs.
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are output | A |
| No CAN communication system DTCs are output | B |
A
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING