Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type) › from 2015.04
RM2040EQ _56 Audio / Visual / Telematics _014718 PARK ASSIST / MONITORING _0169417 TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type) J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)  Clearance Warning ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the clearance warning ECU assembly.

WIRING DIAGRAM

E227013E02
0.382,0.689 1.784,0.845 1.402,0.156 10 from IG1 NO. 2 Relay 2.415,0.95 3.427,1.12 1.011,0.17 10 ECU-IG1 NO. 2 5.306,0.572 5.435,0.742 0.129,0.17 10 1 5.244,1.352 5.421,1.522 0.177,0.17 10 30 5.502,0.683 5.719,0.899 0.216,0.216 10 IG 5.502,1.467 5.658,1.647 0.156,0.179 10 E 5.082,1.928 5.428,2.107 0.346,0.179 10 I82 5.082,2.087 6.618,2.414 1.536,0.328 10 Clearance Warning ECU Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY POWER SOURCE)
a.

Disconnect the I82 clearance warning ECU assembly connector.


b.

Measure the voltage according to the value(s) is the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
I82-1 (IG) - Body ground Power switch on (IG) 11 to 14 V
I82-1 (IG) - Body ground Power switch off Below 1 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I82-30 (E) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR