Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for SD) › from 2014.05
RM2040EQ _56 Audio / Visual / Telematics _014717 NAVIGATION / MULTI INFO DISPLAY _0169499 NAVIGATION SYSTEM(for SD) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for SD)  Cursor or Map Rotates when Vehicle Stopped  


PROCEDURE

1.CHECK CONDITION
a.
E106418

Check with the customer if the vehicle has been turned by a turntable.

OK:

Vehicle has not been turned by a turntable.


HINT:

If the vehicle is turned on a turntable with the power switch turned on (ACC) or on (IG), the system may store the angular velocity. As a result, the vehicle position cursor may deviate. In this case, the vehicle position cursor will return to normal by turning the power switch off and back on (ACC) or on (IG) again with the vehicle completely stopped.



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

TURN THE POWER SWITCH ON (ACC) OR ON (IG) WHEN VEHICLE IS COMPLETELY STOPPED