Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › from 2015.04
RM2040EQ _56 Audio / Visual / Telematics _014718 PARK ASSIST / MONITORING _0075026 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1ABC  Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete  


DESCRIPTION

This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH.

HINT:

This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.


DTC No. Detection Item DTC Detection Condition Trouble Area
C1ABC Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete A beam axis inspection has not been performed. Blind spot monitor sensor LH

PROCEDURE

1.PROCEED TO TEST MODE (BLIND SPOT MONITOR BEAM AXIS INSPECTION)
a.

Change the blind spot monitor sensor LH to Test Mode using the GTS.

HINT:

Refer to Blind Spot Monitor Beam Axis Inspection.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK



Result:
Proceed to
NEXT



NEXT

END