Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
64719A
1.REMOVE LUGGAGE COMPARTMENT DOOR COVER
2.REMOVE LUGGAGE COMPARTMENT DOOR UPPER OUTSIDE GARNISH LH
81270
3.REMOVE LICENSE PLATE LIGHT ASSEMBLY
Disconnect the connector.
Disengage the 2 claws and remove the license plate light assembly.
81274B
4.REMOVE LICENSE PLATE LIGHT PACKING
Remove the license plate light packing.
Do not reuse the removed packing. Be sure to install a new license plate light packing to prevent water ingress.
5.REMOVE LICENSE PLATE LIGHT LENS
| *1 | Protective Tape |
| *a | Insert into the hole |
Insert a screwdriver wrapped with protective tape into the license plate light lens hole, tilt it in the direction shown in the illustration and disengage the 2 claws to remove the license plate light lens.
81270B
6.REMOVE LICENSE PLATE LIGHT BULB
Remove the license plate light bulb.