Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM › from 2016.05
RM2040EQ _51 Engine / Hybrid System _014692 HYBRID / BATTERY CONTROL _0074885 HYBRID CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  P0E33-589  DC/DC Converter Voltage Sensor "A" Low  P0E34-590  DC/DC Converter Voltage Sensor "A" High  


DESCRIPTION

The MG ECU uses a voltage sensor that is built into the boost converter to detect pre-boost high voltage (VL) to allow boost control. The MG ECU monitors the boost converter voltage sensor signal line and detects the following malfunctions.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate
P0E33-589 DC/DC Converter Voltage Sensor "A" Low Open or short to GND in the boost converter voltage (VL) sensor circuit Inverter with converter assembly Comes on Master Warning Light:
Comes on
P0E34-590 DC/DC Converter Voltage Sensor "A" High Short to +B in the boost converter voltage (VL) sensor circuit Inverter with converter assembly Comes on Master Warning Light:
Comes on

PROCEDURE

1.REPLACE INVERTER WITH CONVERTER ASSEMBLY

(Click here Engine / Hybrid System>HYBRID / BATTERY CONTROL>INVERTER WITH CONVERTER>COMPONENTS)

HINT:

The boost converter voltage (VL) sensor is connected to the MG ECU inside the inverter with converter assembly. If P0E33-589 or P0E34-590 is output, replace the inverter with converter assembly.


Result:
Proceed to
NEXT



NEXT

END