NAME PLATE > ATTACHMENT POSITION


  1. Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.

    HINT:
    Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.

  2. Wipe off the remaining double-sided tape using a clean cloth or equivalent.

    NOTICE:
    If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.

  3. After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.

    HINT:
    The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.


Text in Illustration 
*1
NO. 7 LUGGAGE COMPARTMENT DOOR NAME PLATE
*2
NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE
*3
NO. 1 LUGGAGE COMPARTMENT DOOR NAME PLATE
*4
Profile of Luggage Compartment Door Panel
*5
Profile of Luggage Compartment Door Panel
*6
Profile of Fender Panel

Reference Value 
Area
Measurement
Area
Measurement
*a
34.2 mm (1.35 in.)
*b
34.1 mm (1.34 in.)
*c
276.6 mm (10.89 in.)
*d
31.1 mm (1.22 in.)
*e
35.7 mm (1.41 in.)
*f
308.3 mm (1.01 ft.)
*g
86.0 mm (3.39 in.)
*h
165.0 mm (6.50 in.)
*i
86.0 mm (3.39 in.)
*j
170.0 mm (6.69 in.)
*k
251.0 mm (9.88 in.)
*l
161.0 mm (6.34 in.)
*m
161.0 mm (6.34 in.)
*n
248.0 mm (9.76 in.)
*o
172.0 mm (6.77 in.)
-
-

K102626E01


K102627E01