FRONT SUSPENSION CROSSMEMBER > TWO-DIMENSIONAL DISTANCE


HINT:
  1. Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.
  2. In cases in which only one dimension is given, left and right are symmetrical.
  1. For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).


Measuring Point Name 
Symbol
Name
Hole Diameter
mm (in.)
A, a
Front Frame Standard Hole
φ13 (0.51)
B, b
Front Frame Installation Hole
φ62 (2.44)
C, c
Front Frame Standard Hole
φ13 (0.51)
D, d
Front Frame Standard Hole
φ13 (0.51)
E, e
Front Frame Standard Hole
φ13 (0.51)
F, f
Front Suspension Lower Arm Installation Hole
φ15 (0.59)
G, g
Front Frame Installation Hole
φ67.5 (2.66)

K101400E01


K101401E01