REAR SUSPENSION CROSSMEMBER > TWO-DIMENSIONAL DISTANCE


HINT:
  1. Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.
  2. In cases in which only one dimension is given, left and right are symmetrical.
  1. For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).


Measuring Point Name 
Symbol
Name
Hole Diameter
mm (in.)
A, a
Rear Suspension Member Installation Hole
φ49.5 (1.95)
B, b
Rear Suspension Lower Arm Installation Hole
φ16 (0.63)
C, c
Rear Suspension Member Standard Hole
φ15 (0.59)
D, d
Rear Suspension Member Installation Hole
φ49.5 (1.95)
E, e
Rear Suspension Lower Arm Installation Hole
φ16 (0.63)

K101403E01


K101404E01