LIGHTING SYSTEM > GENERAL |
| OUTLINE |
Exterior Lights
The exterior lights consist of the following:

| *1 | Side Turn Signal Light RH | *2 | Side Turn Signal Light LH |
| *3 | Fog Light Assembly RH | *4 | Headlight Assembly RH |
| *5 | Headlight Assembly LH | *6 | Fog Light Assembly LH |
| *7 | Front Turn Signal Light | *8 | Clearance Light |
| *9 | High Beam | *10 | Low Beam |

| *A | Models with Rear Fog Light | - | - |
| *1 | High Mounted Stop Light (Center Stop Light Set) | *2 | Rear Combination Light Assembly LH |
| *3 | Rear Combination Light Assembly RH | *4 | Rear Light Assembly LH |
| *5 | License Plate Light | *6 | Rear Light Assembly RH |
| *7 | Back-up Light | *8 | Rear Fog Light |
| *9 | Tail Light | *10 | Rear Turn Signal Light |
| *11 | Taillight and Stop Light | - | - |
High Intensity Discharge (HID) Headlight System
The HID headlight system uses a metal halide bulb as the light source for each low beam. Discharge bulbs are superior to halogen bulbs.
Automatic Headlight Beam Level Control System
When the headlights are on, the automatic headlight beam level control system operates the headlight leveling motors in accordance with movement of the vehicle.
Automatic Light Control System
When the dimmer switch is in the AUTO position, the light control sensor detects the ambient light level and automatically turns the headlights, taillights, parking lights and license plate lights on or off accordingly.
This system is controlled by the main body ECU (multiplex network body ECU).
Light Auto Turn-off System
The light auto turn-off system is used to prevent the driver from leaving the vehicle with the headlights, front fog lights, parking lights, taillights or license plate lights on.
| SPECIFICATION |
| Light | Type | Wattage | |
| Headlight Assembly | High Beams | Halogen Bulb | 60 |
| Low Beams | Discharge Bulb | 35 | |
| Front Turn Signal Lights | Bulb | 21 | |
| Clearance Light | Bulb | 5 | |
| Side Turn Signal Light Assembly (LH, RH) | Bulb | 5 | |
| Front Fog Light Assembly | Halogen Bulb | 55 | |
| Rear Light Assembly | Backup Lights | Bulb | 16 |
| Tail Lights | Bulb | 5 | |
| Rear Fog Lights* | Bulb | 21 | |
| Rear Combination Light Assembly | Tail Lights/Stop Lights | Bulb | 21/5 |
| Turn Signal Lights | Bulb | 21 | |
| Backup Light | Bulb | 16 | |
| High Mounted Stop Light (Center Stop Light Set) | LED x 4 | 0.8 | |
| License Plate Lights | Bulb | 5 | |
| MAIN FEATURES |
High Intensity Discharge (HID) Headlight System
The light emitted by the bulb is close in color to sunlight. The light shines ahead over a broader area and farther forward, increasing the area visible to the driver.
Less power is consumed compared to halogen headlights.
| PRECAUTION |
High Intensity Discharge (HID) Headlight System
When the HID headlights illuminate, a high voltage (approximately 30000 V) is applied momentarily to the bulb sockets. Never connect a tester to the high voltage socket of a HID headlight for measurement, as this may lead to a serious accident because of high voltage.
Whenever inspecting the HID headlight system, make sure that water or rain is not present, the dimmer switch is off, the battery terminal is disconnected, and the connector of the light control ECU is disconnected in order to prevent an electric shock.
Whenever operating the HID headlights, make sure that it is done only after assembly has been completed and never operate the system without bulbs installed.
Do not operate the HID headlights using a power source other than the vehicle's.
When there is a defect in an HID headlight or any shock has been applied to it, replace the bulb with a new one.
A discharge bulb reaches a high temperature when it is illuminated. For this reason, the life of the bulb could be shortened if any oil comes in contact with the glass portion of the bulb. Do not touch the glass portion of a bulb with bare hands.