LIGHTING SYSTEM > GENERAL



OUTLINE


  1. Exterior Lights



    1. The exterior lights consist of the following:


      Y113381E01


      Text in Illustration 
      *1
      Side Turn Signal Light RH
      *2
      Side Turn Signal Light LH
      *3
      Fog Light Assembly RH
      *4
      Headlight Assembly RH
      *5
      Headlight Assembly LH
      *6
      Fog Light Assembly LH
      *7
      Front Turn Signal Light
      *8
      Clearance Light
      *9
      High Beam
      *10
      Low Beam

      Y111653E01


      Text in Illustration 
      *A
      Models with Rear Fog Lights
      -
      -
      *1
      High Mounted Stop Light (Center Stop Light Set)
      *2
      Rear Combination Light Assembly LH
      *3
      Rear Combination Light Assembly RH
      *4
      Rear Light Assembly LH
      *5
      License Plate Light
      *6
      Rear Light Assembly RH
      *7
      Back-up Light
      *8
      Rear Fog Light
      *9
      Tail Light
      *10
      Rear Turn Signal Light
      *11
      Taillight and Stop Light
      -
      -

  2. High Intensity Discharge (HID) Headlight System

    1. The HID headlight system uses a metal halide bulb as the light source for each low beam. Discharge bulbs are superior to halogen bulbs.

  3. Automatic Headlight Beam Level Control System

    1. When the headlights are on, the automatic headlight beam level control system operates the headlight leveling motors in accordance with movement of the vehicle.

  4. Automatic Light Control System

    1. When the dimmer switch is in the AUTO position, the light control sensor detects the ambient light level and automatically turns the headlights, taillights, clearance lights and license plate lights on or off accordingly.

    2. This system is controlled by the main body ECU (multiplex network body ECU).

  5. Light Auto Turn-off System

    1. The light auto turn-off system is used to prevent the driver from leaving the vehicle with the headlights, front fog lights, clearance lights, taillights or license plate lights on.

  6. Lane Change Flasher System

    1. The lane change flasher system flashes the turn signal light 3 times when the turn signal switch (headlight dimmer switch assembly) is operated partway up or partway down. By using the lane change flasher system when changing lanes, it is no longer necessary to hold the turn signal switch in the lane change position.


SPECIFICATION

Light
Type
Wattage
Headlight Assembly
High Beams
Halogen Bulb
60
Low Beams
Discharge Bulb
35
Front Turn Signal Lights
Bulb
21
Clearance Light
Bulb
5
Side Turn Signal Light Assembly (LH, RH)
Bulb
5
Front Fog Light Assembly
Halogen Bulb
55
Rear Light Assembly
Backup Lights
Bulb
16
Tail Lights
Bulb
5
Rear Fog Lights*
Bulb
21
Rear Combination Light Assembly
Tail Lights/Stop Lights
Bulb
21/5
Turn Signal Lights
Bulb
21
Backup Light
Bulb
16
High Mounted Stop Light (Center Stop Light Set)
LED x 4
0.8
License Plate Lights
Bulb
5
  1. *: Models with rear fog lights

MAJOR DIFFERENCE
  1. The new models have been modified from the previous models as shown below:

    1. A lane change flasher system has been added.


MAIN FEATURES
  1. High Intensity Discharge (HID) Headlight System

    1. The light emitted by the bulb is close in color to sunlight. The light shines ahead over a broader area and farther forward, increasing the area visible to the driver.

    2. Less power is consumed compared to halogen headlights.


PRECAUTION
  1. High Intensity Discharge (HID) Headlight System

    1. When the HID headlights illuminate, a high voltage (approximately 30000 V) is applied momentarily to the bulb sockets. Never connect a tester to the high voltage socket of an HID headlight for measurement, as this may lead to a serious accident due to high voltage.

    2. Whenever inspecting the HID headlight system, make sure that water or rain is not present, the dimmer switch is off, the battery terminal is disconnected, and the connector of the light control ECU is disconnected in order to prevent electric shock.

    3. Whenever operating the HID headlights, make sure that the headlight assembly is complete and never operate the system without bulbs installed.

    4. Do not operate the HID headlights using a power source other than the vehicle's.

    5. When there is a defect in an HID headlight or any shock has been applied to it, replace the bulb with a new one.

    6. A discharge bulb reaches a high temperature when it is illuminated. For this reason, the life of the bulb could be shortened if any oil comes in contact with the glass portion of the bulb. Do not touch the glass portion of a bulb with bare hands.