Home › Brake › BRAKE (REAR) › REAR BRAKE FLEXIBLE HOSE

REAR BRAKE FLEXIBLE HOSE > INSTALLATION

for Preparation Click here


NOTICE:
  1. Because the left and right rear flexible hoses are not interchangeable, verify the part number when installing the flexible hoses.
  2. If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.

HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The following procedure is for the LH side.



1. INSTALL REAR FLEXIBLE HOSE


    C243121E01
  1. Connect the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket.

    Torque:
    33 N*m{ 340 kgf*cm , 25 ft.*lbf }

    Text in Illustration 
    *a
    Lock Hole

    NOTICE:
    Install the flexible hose lock securely into the lock hole in the disc brake cylinder.

  1. Install the rear flexible hose with a bolt.

    Torque:
    19 N*m{ 192 kgf*cm , 14 ft.*lbf }

  1. Install a new clip.

    NOTICE:
    Install the clip as far as it will go.

  1. Using a union nut wrench, connect the brake line to the rear flexible hose while holding the rear flexible hose with a wrench.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

    NOTICE:
    1. Do not bend or damage the brake line.
    2. Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.
    3. Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench (Click here).



2. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL



3. BLEED BRAKE LINE


  1. Bleed brake line.



      C239900
    1. Remove the brake master cylinder reservoir filler cap assembly.

    2. Add brake fluid into the reservoir between the MAX and MIN level on the brake fluid reservoir.

      Brake fluid:
      SAE J1703 or FMVSS No. 116 DOT3

    3. Connect the intelligent tester to the DLC3 and turn the power switch on (IG).

    4. Turn the intelligent tester on and enter the following menus: Chassis / ABS/VSC/TRC / Air Bleeding.

    5. Select "Usual air bleeding" on the intelligent tester display, and bleed air from the brake fluid following the instructions on the intelligent tester.

    6. After air bleeding, tighten each bleeder plug.

      Torque:
      8.3 N*m{ 85 kgf*cm , 73 in.*lbf }

    7. Clear the DTCs (Click here).

    8. Turn the intelligent tester off and turn the power switch off.

  1. Inspect for brake fluid leaks.

  1. Install the brake master cylinder reservoir filler cap.



4. INSTALL FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)
  1. Install the front outer cowl top panel sub-assembly with the 10 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Engage the 2 clamps to install the wire harness to the front outer cowl top panel sub-assembly.

  1. Engage the 2 clamps to install the wire harness to the front outer cowl top panel sub-assembly.



5. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for RHD)



6. INSTALL REAR WHEEL

Torque:
103 N*m{ 1049 kgf*cm , 76 ft.*lbf }