Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROCKER PANEL MOULDING

ROCKER PANEL MOULDING > INSTALLATION

for Preparation Click here



1. INSTALL ROCKER PANEL MOULDING ASSEMBLY
  1. Install the new 10 clips to the rocker panel moulding assembly.

  1. Engage the 10 clips and install the rocker panel moulding assembly.

  1. Install the screw.

  1. Install the 7 clips.

  1. Install the screw.

  1. Install a new grommet and 2 screws.



2. INSTALL FRONT ROCKER PANEL MOULDING END COVER
  1. Install the front rocker panel moulding end cover with the 2 screws.