Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROCKER PANEL MOULDING

ROCKER PANEL MOULDING > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. INSTALL ROCKER PANEL MOULDING
  1. Install 10 new clips to the rocker panel moulding.

  1. Engage the 10 clips to install the rocker panel moulding.

  1. Install the screw.

  1. Install 7 new clips.

  1. Install the screw.

  1. Install a new grommet and the 2 screws.



2. INSTALL FRONT ROCKER PANEL MOULDING END COVER
  1. Install the front rocker panel moulding end cover with the 2 screws.