ROCKER PANEL MOULDING > REMOVAL |
| 1. REMOVE FRONT ROCKER PANEL MOULDING END COVER |
![]() |
Remove the 2 screws and front rocker panel moulding end cover.
| 2. REMOVE ROCKER PANEL MOULDING |
Apply protective tape around the rocker panel moulding and door as shown in the illustration.

![]() | Protective Tape | - | - |
![]() |
Remove the 2 screws and grommet.
![]() |
Remove the screw.
![]() |
Using a clip remover, remove the 7 clips.
![]() |
Remove the screw.
![]() |
Disengage the 10 clips and remove the rocker panel moulding.
Remove the 10 clips from the rocker panel moulding.