SFI SYSTEM (w/ EGR System) > DTC CHECK / CLEAR |
| CHECK DTC |
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Check the DTCs and freeze frame data, and then write them down.
Check the details of the DTCs (Click here).
| CLEAR DTC (Using the GTS) |
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Clear the DTCs.
| CLEAR DTC (Without using the GTS) |
Perform either of the following operations:
Disconnect the cable from the negative (-) auxiliary battery terminal for more than 1 minute.
Remove the EFI NO. 1 and ETCS fuses from the engine room relay block and junction block assembly located inside the engine compartment for more than 1 minute.